A curved staircase and the floor around it, treated as one job. The treads, nosings and risers were cut to the curve and finished to match the engineered hardwood running through the main floor and the upper landing.

The house already had a curved staircase — the geometry stays, the finishes change. Our photograph of the upper landing before the work shows what we started with: a dark-stained floor running through the hall and around the opening, and a white turned balustrade above a stained handrail.
We installed engineered hardwood through the main floor, the hallway and the upper landing, and rebuilt the staircase to go with it. New oak treads were made for the curve. The nosings were cut to follow it too, which is the part of a curved stair that has to be right — a straight nosing on a curved tread shows immediately, at every step.
New risers went in behind them, and the finishing details around the stair were matched to the new flooring so the stair and the floor read as one surface rather than two that happen to meet.
The balustrade was dealt with in two different ways, because two different things were needed. The white turned spindles were replaced. The handrail was not — it was kept, sanded back, stained and varnished to the tone of the new floor, so the rail you actually put your hand on belongs to the hardwood underneath it.
The photographs show the stair from the main floor, from above, and from the landing, with the floor carried through the hallway to the front entry. The same landing appears before and after, from close to the same spot, which is the clearest way to see what changed.
Before

After

Tell us what you have in mind. Estimates are free, measured at your home and put in writing before anything is ordered.
← → to move · Esc to close